Paper lace, a little ribbon and three shades of red make a lovely Valentine's craft afternoon. Pick a layered card to send, a doily wreath for an interior door, a ribbon-banded note or a small framed collage. The projects share supplies, so your leftover hearts can become the next piece.
Each project below makes one finished piece. The measurements give you a starting size, so you don't have to guess how large the hearts should be or whether the paper will wrap around the card. Choose cream, dusty rose and burgundy for a coordinated set.
Paper, Ribbon and a Few Tools
For the whole set, gather four sheets of 8½-by-11-inch cardstock in cream, two in rose and one in burgundy; eight 6-inch paper doilies; a 12-inch square of lightweight cardboard; and about 2 yards of narrow ribbon. You'll also need scrap patterned paper, scissors, a pencil, a ruler, a glue stick, craft glue suited to paper and cardboard, and removable tape.
For the collage, add a frame with a 5-by-7-inch opening and its backing. Use paper you can cut comfortably with scissors. Test glue on a doily scrap before starting, and follow its drying instructions. Set wet pieces aside flat rather than stacking them.
Make a Layered Heart Card
This card folds to 4¼ by 5½ inches. Set aside one cream cardstock sheet, a 4-by-5-inch rose scrap, a 3-by-4-inch burgundy scrap and one doily.
1. Cut the 11-inch length of the cream sheet in half to make two 8½-by-5½-inch rectangles. Take one rectangle and fold its 8½-inch width in half to make a 4¼-by-5½-inch card. Press the crease with the side of a ruler.
2. Fold the rose scrap in half lengthwise. Draw half a heart against the fold, keeping the finished shape within 3½ inches wide and 4 inches tall. Cut through both layers and open it.
3. Make a second heart, about 2½ inches wide and 3 inches tall, from the burgundy scrap.
4. Place the rose heart on the card. Slip a doily fragment behind its left edge, leaving about ½ inch of lace showing. Trim any paper that extends beyond the card.
5. Glue the doily fragment down, then the rose heart, then the burgundy heart. Keep the glue thin and let the card dry flat.
Write your message inside before adding a ribbon. For mailing, try the card in its envelope before attaching a bow; the flat paper layers are lovely on their own.
Build a Small Doily Wreath
For an indoor wreath about 14 inches across, use the cardboard square, six 6-inch doilies, three paper hearts and a 12-inch ribbon length. Cut one heart about 3 inches tall and two about 2 inches tall.
1. Draw a 9-inch circle on the cardboard, then a centered 6-inch circle inside it. Cut out the ring. If the cardboard is difficult to cut with scissors, choose thinner material.
2. Before covering the ring, loop the ribbon around its top and tie the ends together. Rotate the knot behind the cardboard.
3. Lay six doilies around the ring like overlapping petals. Keep their centers over the cardboard band and leave the middle opening visible. Shift them until their scalloped edges form an even outline.
4. Lift one doily at a time and glue its solid center to the ring. Work in the same direction around the circle, letting each overlap the previous one.
5. Glue the three hearts in a cluster near the lower right edge, largest behind the others. Let everything dry before lifting the ribbon loop.
Hang it on an interior door or wall. Paper doilies won't stand up to rain, and the finished wreath belongs away from heat and candles.
Wrap a Note With a Sliding Band
Use the remaining half of your first cream sheet to fold another 4¼-by-5½-inch card. You'll need an 11-by-1¼-inch paper strip, an 8-inch ribbon length and a 2-inch paper heart.
1. Write the note inside and close the card.
2. Lay the paper strip horizontally across its middle. Fold the ends around the back, leaving enough slack for the band to slide.
3. Glue the overlapping ends to each other, keeping adhesive off the card. Slide the band off while it dries.
4. Fold the ribbon into a loose loop with both cut ends together. Glue those ends to the front of the band, then cover the join with the heart.
5. Once dry, slide the band back onto the card.
For a flatter version, leave out the ribbon and draw a little loop around the heart with a fine pen. The recipient should be able to slide off the band without tearing the note.
Frame a Heart Collage
Cut cream cardstock to fit your frame backing. For a 5-by-7-inch collage, gather a rose heart about 3 inches tall, a 1-by-6-inch patterned strip, a small doily fragment and a 2-by-¾-inch handwritten label.
1. Place the patterned strip vertically, about ¾ inch from the left edge of the cream card.
2. Lay the heart across it, slightly below the center. Tuck the doily fragment behind one side.
3. Set the label near the heart's lower edge. Write a name, a short greeting or a word in your own handwriting.
4. Move the loose arrangement into the frame opening to check what the edges hide. Then remove it and glue the pieces down in layers.
5. Let it dry before framing. Keep the layers thin enough that the backing closes without force.
A red gingham scrap changes the mood more than another embellishment would. For a softer picture, use a plain rose strip and let the scalloped edge provide the pattern.
Use the Leftover Hearts
Cut the remaining paper into small gift tags, or save matching scraps in an envelope with the finished heart template. Mark the template's height on its back so you can remake the same size later.
Choose someone for the first card before you put away the supplies. A few lines in your own handwriting will make the paper and ribbon feel like a gift.
A handmade heart card also makes a lovely companion to a writing gift. For someone who enjoys darker botanical artwork, our Owl and Roses journal gives the pale paper and ribbon a contrasting backdrop; tuck the card inside when you wrap it.









